Brake Light Switch — Check (Mitsubishi Pajero 1)

Contents: Brake light switch terminals ⤓ Examination ⤓

Brake light switch terminals

Examination

1. Disconnect the connector and check for continuity between the following terminals: 2–3 – when the brake pedal is pressed, 1–4 – when the pedal is released.

2. Replace the switch if its operation differs from that described.

[The original article is on: www.mitsubishiman.ru]

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article was reviewed by: Arseny Pavlov

Share with friends:

◀ Previous

Pajero 1 and 2: Cruise control

Next ▶

Steering column switch
Checking the main switch

Clutch release sensor (vehicles with manual transmission)
Automatic transmission lock switch
Solenoid valve and actuator — removal, inspection and installation

Similar materials for other Mitsubishi models