Contents: Location of the starter on the engine ⤓ Direct Drive Starter ⤓ Starter with gearbox ⤓ Technical data of starters ⤓ Removal ⤓ Installation ⤓
Location of the starter on the engine
1. Lid
2. Starter
Direct Drive Starter
1. Screw; 2. Traction relay; 3. Seal; 4. Emphasis; 5. Screw; 6. Tie bolt; 7. Back cover; 8. Rear bearing; 9. Brush holder; 10. Yoke with windings; 11. Anchor; 12. Lever; 13. Washer; 14. Retaining ring; 15. Limiting sleeve; 16. Overrunning clutch; 17. Front cover
Starter with gearbox
1, 3, 4. Screw; 2. Traction relay; 5. Back cover; 6. Brush holder; 7. Brush; 8. Rear bearing; 9. Anchor; 10. Yoke; 11. Ball; 12, 13. Seals A and B; 14. Emphasis; 15. Planetary gear; 16. Lever; 17. Retaining ring; 18. Limiting sleeve; 19. Overrunning clutch; 20. Drive gear; 21. Holder; 22. Front cover
Technical data of starters
Removal
1. Disconnect the battery from ground.
2. Raise the front of the vehicle.
3. Disconnect the wires, unscrew the 2 mounting bolts and remove the starter.
Installation
1. Installation is carried out in reverse order.
2. Tighten the bolts to the required torque.