Removal and installation
1. Remove the heat shield.
2. Disconnect the front and rear exhaust pipes and remove the neutralizer.
3. Installation is carried out in reverse order.
Middle section
4. Raise the vehicle and apply penetrating liquid to the nuts and bolts.
5. Disconnect the pipe from the neutralizer and from the muffler and remove.
6. Installation is carried out in reverse order.
End section
7. Disconnect the middle section from the neutralizer.
8. Remove all brackets and clamps.
9. Disconnect the pipe and remove the end section.
10. Installation is carried out in reverse order.
(The article is based on data from the website: «MitsubishiMan.ru»)