Installing the SRS electronic unit (Mitsubishi Pajero 4)

1. Install the SRS electronic control unit (2).

Caution: The SRS may not deploy if the electronic control unit is not connected correctly, which could result in serious injury or death to the driver or front passenger.

2. Install the engine control unit, automatic transmission control unit, and automatic transmission control relay (1).

3. Install the lower cover and side cover of the instrument panel.

4. Connect the negative battery terminal.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article was reviewed by: Miroslav Rakov

Share with friends:

◀ Previous

Pajero 4: Safety system (SRS)

Next ▶

Removal the SRS electronic unit
SRS Electronic Control Unit
Front Wiring Harness/Floor Wiring Harness
Side impact sensor
Front seat back assembly (side airbag module)

Removal the SRS electronic unit
Installing the SRS electronic unit
Checking the correct installation
Airbag modules and clock spring
Removal the airbag modules and clock spring

Similar materials for other Mitsubishi models