1. Raise the rear of the vehicle and support it on stands.
2. Unscrew the nut on the left end of the transverse rod, as well as the bolt and nut on the right end of the rod. Disconnect the rod from the brackets and remove it from the car
3. Install in the reverse order. Tighten the fasteners to the torque specified in specifications of this Chapter.
Cross tie rod — removal and installation (Mitsubishi Galant 5)
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This article was reviewed by: Vladimir Glazunov
Share with friends:
Similar materials for other Mitsubishi models
➤ Cross section of 4D65T diesel engine Mitsubishi Colt 4 and 5 (1991-2003)
➤ Front suspension cross beam Mitsubishi Lancer 9 (2000-2007, petrol)
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- Introduction to guide
- User manual
- Driving and operation
- Maintenance
- Power unit
- Dismantling the engine
- Engine overhaul
- Cooling and heating
- Power and exhaust systems
- Engine electrical equipment
- Engine management systems
- Transmission
- Mechanical gearbox
- Automatic gearbox
- Clutch
- Drive shafts and transfer case
- Chassis and running gear
- Brake system
- Car suspension
- Steering
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Wiring diagrams Galant
- Wiring diagrams Mirage
- Wiring diagrams Diamante
- General information
- Troubleshooting
- Maintenance
- Power unit
- Engine repair
- Engine overhaul
- Cooling and heating
- Fuel and exhaust system
- Engine electrical equipment
- Reducing exhaust toxicity
- Transmission
- Manual gearbox
- Automatic gearbox
- Clutch and drive shafts
- Chassis and running gear
- Brake system
- Car suspension
- Steering
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Electrical diagrams