- ATF Dexron or Dexron-II.
- Place the vehicle on a level surface, start the engine and let it idle.
- Turn the steering wheel repeatedly in different directions until the operating temperature of the fluid in the steering system is reached (about 50° + 60°C)
- Turn the steering wheel left and right repeatedly until it stops. Caution: Do not leave the steering wheel in the extreme position for longer than 10 seconds.
- Make sure that there is no foam or cloudiness in the expansion tank.
Cars produced from 9.88 to 3.92
- Check the oil level in the tank with the engine running, add oil to the tank if necessary, left side of the picture.
- it is essential to add new oil, as even the smallest particles of dirt can cause the hydraulic system to fail.
- stop the engine and measure the level in the tank. If the difference is greater than that shown in the figure, remove air from the system, see item 16.8.
- After adding oil, check the tightness of the system.
Cars produced from 1.84 to 8.88
- Open the screw cap of the expansion tank with the engine running.
[The article was obtained from this portal www.mitsubishiman.ru]
- The oil level should be between the MAX and MIN marks.
