When properly adjusted, the door panel should be flush with the adjacent body panels.
The position of the door along the body surface is adjusted by moving it with the bolts securing the hinges to the body loosened.
The door protrusion above the body surface is adjusted by loosening the bolts securing the hinges to the door.
The reliability of door locking is determined by the position of the door lock retainer.
The manufacturer also provides for the installation of adjustment plates under the retainer.
When adjusted correctly, the door should not move up or down when slammed.
(The article was obtained from this portal: www.MitsubishiMan.ru)
1. To adjust the retainer, loosen the screws (on the left) of the fastening with an impact screwdriver (these screws are tightened tightly (on the right – the adjustment plate)).
2. Then move the latch and close the door, keeping the outside handle in the unlocked position.
3. Tighten the screws when locking the door with the latch (the latch tongue then enters the retainer).
4. When the door is adjusted correctly, the latch is adjusted only in the horizontal direction.