Luke (1992-98)
1. Switch; 2. Electric drive; 3. Control unit; 4. Rear bracket; 5. Luke; 6. Front bracket; 7, 8. Drainage hoses
1. Disconnect the battery from ground.
2. Remove the switch panel and disconnect the wiring.
3. Remove the headlining (see subsection 12.27).
4. Close the sunroof and remove the sunroof motor (if the hatch cannot be closed, mark the position of the cover and guide).
5. Mark the position of the drive gearbox on the bracket.
6. Remove the control unit.
7. Remove the rear bracket, take out the sunroof assembly and remove the front bracket.
8. Remove drain hoses only when necessary.
9. To remove the hose, attach a cord to it, wrap it with tape and pull the hose into the passenger compartment (1 – seal, 2 – tape, 3 – cord, 4, 5 – hose).
10. Installation is carried out in reverse order.
11. Pull the hose through, securing the cord to it with adhesive tape (left – front drainage hose, right – rear; 1 – seal, 2 – hose).
12. When replacing the electric motor, open the hatch by 20 cm and position the gearbox hole so that it is between the teeth of the electric motor gear (1 – gearbox gear, 2 – drive gear, 3 – hole).
13. When installing the removed drive, align the applied marks.