Contents: Rear Anti-Roll Bar (1989-91) ⤓ Rear Anti-Roll Bar (1992-98) ⤓ The order of installation of washers…⤓ Cars with rear axle springs ⤓
Rear Anti-Roll Bar (1989-91)
1. Handbrake cable bolt; 2. Shock absorber mounting bolts; 3. Clamp; 4, 7, 9. Bushing; 5. Stabilizer bar bolt and nut; 6. Cap; 8. Bushing; N – replace
*1 – tighten after lowering the vehicle
*2 – only for cars with 4-door body
Rear Anti-Roll Bar (1992-98)
1.3. Handbrake cable bolt; 2. Wiring bracket bolt; 4. Speed sensor mounting bolt (on cars with ABS system); 5. Shock absorber mounting bolts; 6. Bracket; 7. Bushing; 8. Stabilizer bar bolt and nut; 9. Cap; 10. Rubber bushing; 11. Rack bushing; 12. Stabilizer
* – tighten after lowering the vehicle
The order of installation of washers and bushings on the stabilizer strut
1. Cap; 2. Rubber bushings; 3. Stabilizer; 4. Rack bushing
Cars with rear axle springs
1. Raise the rear of the vehicle, remove the wheels and disconnect the handbrake cable.
2. Unscrew the bolt of the wiring and speed sensor bracket (on car parts).
3. Place stands under the rear axle and unscrew the bolts of the lower shock absorber mounts.
4. Remove the stabilizer brackets.
5. Unscrew the nuts and remove the washers and bushings, paying attention to the location of these parts.
6. Carefully lower the axle, making sure that the springs do not fall out and the brake pipe is not deformed, remove the stabilizer on the right side.
7. Installation is carried out in reverse order.
8. Tighten the connections to the specified torques. Tighten the stabilizer bar nut 15–17 mm from the end of the bar.