Steering shaft assembly (Mitsubishi Pajero 4)

1. Install the steering shaft assembly (4).

2. Install the ignition switch (3).

3. Install the steering column lock bracket (2).

4. Tighten the special bolt (1).

Attention: When replacing the ignition switch, the lock bracket and special bolts must be replaced with new ones.

Article reprinted from the website (MitsubishiMan.ru)

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article was reviewed by: Miroslav Rakov

Share with friends:

◀ Previous

Pajero 4: Steering

Next ▶

Removal the power steering gear
Disassembling the steering shaft
Installing the steering shaft
Removal the steering shaft
Installing the steering wheel

Installing a power steering gear
Removal the power steering pump
Installing a Power Steering Pump
Checking the power steering pump
Removal the power steering hydraulic hoses

Similar materials for other Mitsubishi models

➤ Steering wheel and steering shaft — design description Mitsubishi Colt 5 (1995-2003, petrol)
➤ Steering / Front Wheel Drive Mitsubishi Lancer 3 and 5 (1984-1992)
➤ Left combination steering column switch (exterior lighting… Mitsubishi Galant 6 and 7 (1987-1998)
➤ Disassembling the steering column shaft Mitsubishi L200 4 (2005-2014, diesel)
➤ Removal and installation the steering column shaft Mitsubishi Outlander 1 (2003-2008)
➤ Steering wheel and steering shaft — removal and installation Mitsubishi Carisma (1995-2004)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

Pajero 4 (2006-2021)

Pajero 1 and 2 (1982-1999)