Contents: Removal ⤓ Installation ⤓
Removal
To remove the front wing, perform the following operations.
1. Remove the front bumper.
2. Remove the headlights.
3. Remove the side fairing.
Fig. 17.4. Front wing: 1 – mudguard; 2 – side turn signal repeater; 3 – wing; 4 – support bracket
[The article is based on data from the website: MitsubishiMan.ru]
4. Unscrew the self-tapping bolts and remove the mudguard 1 (Fig. 17.4).
5. Remove the side turn signal repeater 2.
6. Loosen the bolts around the perimeter of the wing and remove wing 3.
7. If necessary, remove the wing support bracket 4.
Installation
1. Clean off any old sealant from the body surface mating with the wing and apply a thick layer of fresh sealant.
2. Install the wing on the car and secure it with bolts, tightening them by hand at this stage. Move the wing to adjust its position and tighten the bolts.
3. Install the front bumper.
4. Install the headlights.
5. Install the side fairing.