Expansion tank of the cooling system — removal and installation (Mitsubishi Colt 2)

1. Remove the expansion tank cap and disconnect the water hose.

7.2 Release the plug and hose, unscrew the bolt (indicated by the arrow), then remove the expansion tank.

2. Loosen the bolts and remove the tank from the vehicle (7.2).

3. Installation is carried out in the reverse order of removal.

The original article is on the website MitsubishiMan

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article was reviewed by: Arseny Pavlov

Share with friends:

◀ Previous

Colt 2 and 3: Cooling system

Next ▶

Coolant Temperature Sensor — Checking and Replacing
Engine cooling fan — checking and replacing elements
Radiator — removal and installation
Thermostat — Checking and Replacing
Antifreeze — General Information

Water pump — check
Water Pump — Replacement and Installation

Similar materials for other Mitsubishi models

➤ Checking the tightness of the cooling system Mitsubishi Lancer 3 and 5 (1984-1992)
➤ Removal and installation the cooling system radiator Mitsubishi Galant 6 and 7 (1987-1998)
➤ Electronic immobilizer (anti-theft system that blocks… Mitsubishi L200 4 (2005-2014, diesel)
➤ Checking for leaks in the cooling system Mitsubishi Outlander 1 (2003-2008)
➤ Cooling system hoses Mitsubishi Pajero 1 and 2 (1982-1999)
➤ Checking the tightness of the cooling system Mitsubishi Carisma (1995-2004)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet