Home Colt Lancer Galant L200 Outlander Pajero Others

Colt 5 (1995-2003, petrol) Colt 4 and 5 (1991-2003) Colt 2 and 3 (1983-1993)

Checking the fuel injector (Mitsubishi Colt 5)

0

Measuring the resistance between the injector terminals

1. Disconnect the connector from the injector (Figure 8.22).

Figure 8.22. Measuring voltage between injector terminals

2. Measure the resistance between the connector terminals. Normal value: 13-16 Ohm at 20°C.

3. Connect the connector.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article was reviewed by: Peter Ermakov

Share with friends:

◀ Previous

Colt 5: Injection system MPI

Next ▶

Checking the idle speed sensor
Throttle Position Sensor
Checking the coolant temperature sensor
Checking the inlet air temperature sensor
Checking the electrical continuity of the control relay and fuel pump relay

Similar materials for other Mitsubishi models

➤ Checking the fuel shut-off valve Mitsubishi Lancer 3 and 5 (1984-1992)
➤ Checking the condition of the fuel evaporative emission… Mitsubishi Galant 6 and 7 (1987-1998)
➤ Checking the condition of fuel lines Mitsubishi L200 4 (2005-2014, diesel)
➤ Checking the fuel level sensor Mitsubishi Outlander 1 (2003-2008)
➤ Checking the air-fuel mixture composition at idle Mitsubishi Pajero 4 (2006-2021)
➤ Checking the air-fuel mixture at idle speed Mitsubishi Carisma (1995-2004)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

This resource sets cookies 🍪 to avoid bothering you with repeated data entry.