Hood (on the insert – places for lubrication of the lock)
1, 7. Buffer; 2. Bracket; 3. Vibration damper; 4, 6. Seal; 5. Thermal insulation layer; 8. Rack; 9. Cable shield; 10. Castle; 11. Drive handle; 12. Cable; 13. Hood
Removal and installation
Attention! Work is performed by two people.
1. Open the hood and outline the hinges.
2. Disconnect the underhood lamp connector and washer hoses (if provided).
3. Unscrew the hood hinge bolts and remove the hood.
The text of the article was taken from the website: www.mitsubishiman.ru
4. Install the hood in reverse order.
5. Adjust the bonnet and tighten the bolts to 14 Nm.