2. Install the rectifier unit (13).
3. Install the dust ring (12).
4. Install the generator brush (11).
5. Install the voltage regulator assembly (10).
6. After installing the voltage regulator assembly, to fix the brushes in the raised position, insert a piece of wire into the hole in the rear bracket of the generator.
Note: Securing the brushes in a raised position with wire makes subsequent rotor installation easier.
7. Install the plate (9).
8. Install the stator (8).
9. Install the front bracket (7).
10. Install the front generator bearing (6).
Article reprinted from the website www.mitsubishiman.ru
11. Install the bearing holder (5).
12. Install the generator rear bearing (4).
13. Install the rotor (3).
14. After installing the rotor, remove the piece of wire securing the brushes.
15. Install the generator pulley (2).
16. Install the front bracket assembly (1).