Adjusting the axial play of the rear axle shaft (Mitsubishi Pajero 1)

1. On the left axle shaft, place a 1 mm thick washer between the bearing housing and the end of the axle beam.

2. Install the right half shaft without the adjusting washer and ring, tighten the 4 nuts to a torque of 5.6 N·m.

3. Check the clearance between the bearing housing and the end of the bridge beam.

4. Remove the axle shaft and install washers with a thickness equal to the measured gap plus 0.05–0.20 mm.

5. Install the ring, lubricating it with sealant.

6. Install the axle shaft and tighten the nuts to 54 Nm.

The article is reprinted from a web resource: www.mitsubishiman.ru

7. Check the axial play and continue assembly.