Model with 6V31 engine
Note: When installing, tighten the bolts to the torques shown in the figure.
1. Install the cylinder block (18).
2. Install the stiffener gasket (17).
3. Install the stiffener (16).
4. Install the knock sensor (15).
5. Install the knock sensor (14).
6. Install the touch ring (13).
7. Install the upper crankshaft bearing (12).
8. Install the support bearing (11).
9. Install the crankshaft (10).
10. Install the lower crankshaft bearing (9).
11. Install the bearing cover (8).
12. Tighten the bearing cover bolt (7).
13. Install the seal housing (6).
14. Install the rear crankshaft oil seal (5).
15. Install the back plate (4).
16. Install the flywheel (3).
17. Install the adapter plate (2).
18. Tighten the flywheel bolt (1).
Model with 6G7 engine
1. Install the cylinder block (16).
2. Install the knock sensor bracket (15).
3. Install the knock sensor (14).
4. Install the upper crankshaft bearing (13).
5. Install the support bearing (12).
6. Install the crankshaft (11).
7. Install the lower crankshaft bearing (10).
8. Install the bearing cover (9).
9. Tighten the bearing cover bolt (8).
10. Install the reflector (7).
11. Install the rear crankshaft oil seal (6).
12. Install the housing seal (5).
13. Install the back plate (4).
14. Install the crankshaft adapter (3).
15. Install the drive disk (2).
16. Install the connecting plate (1).
Model with 4M4 engine
1. Install the cylinder block (24).
2. Install the oil spray nozzle (23).
3. Install the test valve (22).
4. Install the upper crankshaft bearing (21).
5. Install the upper support bearing (20).
6. Install the crankshaft (19).
7. Install the lower crankshaft bearing (18).
8. Install the upper support bearing (17).
9. Install the sealing ring (16).
10. Install the lower part of the cylinder block (15).
11. Install the bearing (14).
12. Install the bearing (13).
13. Install the crankshaft key (12).
14. Install the crankshaft gear (11).
15. Install the front plate (U).
16. Install the left engine mounting bracket (9).
17. Install the right engine mounting bracket (8).
18. Install the rear housing seal (7).
19. Install the rear oil seal (6).
20. Install the rear housing oil seal assembly (5).
21. Install the back plate (4).
22. Install the ball bearing (3).
23. Install the flywheel (2).
24. Tighten the flywheel bolt (1).
Information copied from the website: mitsubishiman.ru