Fig. 17.7. Using the special tool MB990900 or MB991164 (1) to adjust the door installation position
1. If the gap between the door and the body is uneven, stick protective tape on the mating surface of the door and around the door hinge on the body. Then loosen the bolts securing the door hinge to the body and use the special tool MB990900 or MB991164 to adjust the gap between the door and the body (Fig. 17.7).
2. If the closed door is not flush with the body surface, use a special tool to adjust its position after loosening the bolts securing the door hinges to the body.
3. If the door is difficult to open and close, adjust the position of the lock and latch by adjusting the position of the latch.
The article was taken from the website www.MitsubishiMan.ru