Contents: Removal ⤓ Installation ⤓
Removal
To remove the clutch pedal, perform the following operations.
1. Open the door and support it with a jack through a wooden block. Disconnect the electrical connector of the wiring harness from the mirror, window lifters and central lock.
2. Remove the bolts securing the door opening stop.
3. Use a punch to knock out the split pins and remove the door.
Fig. 17.9. Doors: A - front door; B - rear door; a – lubrication point; 1 – wiring harness connector; 2 – lower door hinge; 3 – split pin (needs to be lubricated); 4 – upper door hinge; 5 – lock retainer; 6 – door limit switch; 7 – door limit switch cover; 8 – door assembly
4. If necessary, unscrew the bolts and remove the door hinges 4 (Fig. 17.9).
5. If necessary, unscrew the screw, remove cover 7 and take out the door limit switch.
Installation
Installation is carried out in the reverse order of removal, taking into account the following.
1. Lubricate the door hinges with grease.
2. Install the door and secure it with bolts to the hinges.
Fig. 17.10. Location of the mark (1) on the door opening limiter
3. Install the door opening limiter so that the marking is on top (Fig. 17.10) and screw it in place. Depending on the installation location, the limiter has distinctive markings:
[The material was created based on the website: www.MitsubishiMan.ru]
- FL – left front door;
- RL – left rear door;
- FR – right front door;
- RR – right rear door.
4. Connect the electrical connector of the wire harness.
5. If the closed door is not flush with the body surface, use a special tool to adjust its position after loosening the bolts securing the door hinges to the body.
Fig. 17.8. Checking the safety mechanism of the electric window lifter
6. If opening and closing the door is difficult, adjust the position of the lock and latch by adjusting the position of the latch (see Fig. 17.8).
7. Adjust the door installation position.