Contents: Front doors ⤓ Rear doors ⤓
Front doors
Removal
To remove the lock and door handle, follow these steps.
1. Disconnect the cable from the negative terminal of the battery.
2. Remove the door trim.
3. Loosen the self-tapping screw and remove the inner door opening handle.
4. Remove the waterproof film.
Fig. 17.20. Front door lock and handles: a - lubrication points; 1 – door opening limiter; 2 – split pin; 3 – outer door handle; 4 – front door lock cylinder; 5 – door lock assembly; 6 – lower rear glass guide; 7 – inner door handle
5. Remove the lower rear glass guide 6 (Fig. 17.20).
6. Disconnect the rod from the front door lock handle.
7. Loosen the screw and remove the outer handle 3 of the door.
8. Remove cylinder 4 of the front door lock.
9. Unscrew the three screws and remove the door lock assembly 5.
Fig. 17.21. Location of the electronic unit (1) for controlling the door locking system on vehicles with central door locking, except for vehicles equipped with a remote door lock control system
10. If necessary, remove the electronic control unit of the door lock system (vehicles with central door locking, except for vehicles equipped with a remote door lock control system) (Fig. 17.21).
Installation
Installation is carried out in the reverse order of removal, taking into account the following.
1. Check the stroke of the inner door handle.
2. Install the door trim.
3. Adjust the door installation.
Rear doors
Removal
To remove the lock and door handle, follow these steps.
1. Remove the door trim.
2. Loosen the self-tapping screw and remove the inner door opening handle.
3. Remove the waterproof film.
4. Disconnect the rods from the rear door lock handle.
Fig. 17.22. Rear door lock and handles: a - lubrication points; 1 – door opening limiter; 2 – split pin; 3 – inner door handle; 4 – outer door handle; 5 – screw (6 Nm); 6 – door lock assembly
5. Loosen the screw and remove the outer handle 4 (Fig. 17.22) of the door.
6. Unscrew the three screws and remove the door lock assembly 6.
Installation
Installation is carried out in the reverse order of removal, taking into account the following.
1. Check the stroke of the inner door handle.
2. Install the door trim.
3. Adjust the door installation.