Fig. 7.13. Location of connector contacts (1) and throttle position sensor (2)
1. Disconnect the throttle position sensor connector (see Fig. 7.13).
2. Check the circuit between contacts "3" and "4" of the connector on the throttle position sensor side. When the pedal is pressed, the sensor resistance should be equal to infinity, and when the pedal is released, it should be equal to zero.
3. If the circuit conditions do not match those specified above, replace the throttle position sensor.
Attention! After replacement, it is necessary to adjust the position of the throttle valve sensor and the fully closed throttle valve switch.
(The material is based on data from the website www.MitsubishiMan.ru)