Coolant reservoir — removal and installation (Mitsubishi Galant 5)

1. Remove the cap from the coolant reservoir and pull out the tube.

2. Loosen the bolt securing the coolant reservoir to the fender, then remove the reservoir. The windshield washer reservoir can remain in place.

7.2 Pull out the cap and hose, unscrew the bolt (shown by the arrow), and then remove the coolant reservoir

3. Install in reverse order.

(The article is based on data from the website: MITSUBISHIMAN.ru)

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article was reviewed by: Vladimir Glazunov

Share with friends:

◀ Previous

Galant 5: Cooling and heating

Next ▶

Coolant Temperature Sensor — Checking and Replacing
Engine Cooling Fan — Checking and Replacing
Radiator — removal and installation
Thermostat — Checking and Replacing
Antifreeze — General Information

Water pump — check
Water pump — removal and installation
Air Conditioner and Heater Blower Motor — Removal and Installation
Heater Radiator — Replacement
Heater and Air Conditioner Control Unit — Removal and Installation and Cable Adjustment

Similar materials for other Mitsubishi models

➤ Checking the coolant level Mitsubishi Colt 4 and 5 (1991-2003)
➤ Checking the coolant level Mitsubishi Lancer 3 and 5 (1984-1992)
➤ Checking the coolant level Mitsubishi L200 4 (2005-2014, diesel)
➤ Replacing the coolant Mitsubishi Outlander 1 (2003-2008)
➤ Fuel level and coolant temperature sensor Mitsubishi Pajero 1 and 2 (1982-1999)
➤ Replacing the coolant Mitsubishi Carisma (1995-2004)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet