Checking the axial clearance in the front wheel hub bearing (Mitsubishi Pajero 4)

1. Install the special tool on the front wheel hub assembly and tighten the nut to the specified torque of 220±10 N·m.

2. Measure the clearance in the axial direction.

Maximum allowable value: 0.0 mm.

3. If the maximum permissible value of axial clearance in the front wheel hub bearing is not observed, replace the front wheel hub assembly.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article was reviewed by: Miroslav Rakov

Share with friends:

◀ Previous

Pajero 4: Drive shafts

Next ▶

Checking the resistance moment of the front wheel hub bearing rotation start
Installing the hub and steering knuckle
Removal the hub and steering knuckle
Rear axle oil change
Checking the oil level in the rear axle

Disassembling the hub and steering knuckle
Assembly of the hub and steering knuckle
Removal the drive shaft
Installing the drive shaft
Disassembling the drive shaft

Similar materials for other Mitsubishi models

➤ Crankshaft — Installation and Checking of Main Bearing… Mitsubishi Colt 2 and 3 (1983-1993)
➤ Checking the axial clearance of the front wheel hub Mitsubishi Lancer 9 (2000-2007, petrol)
➤ Crankshaft — installation and checking of main bearing… Mitsubishi Galant 5 (1983-1989, petrol)
➤ Checking the front wheel hub bearing adjustment Mitsubishi L200 4 (2005-2014, diesel)
➤ Checking the play in the front hub bearings Mitsubishi Outlander 1 (2003-2008)
➤ Checking the front wheel hub play Mitsubishi Space Star (1998-2005)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

Pajero 4 (2006-2021)

Pajero 1 and 2 (1982-1999)