Note: When installing, tighten the bolts to the torques shown in the figure.
1. Install the ring clamp (18).
2. Install the drive shaft assembly (17).
Note: When installing the drive shaft, it is necessary to apply grease to the places indicated in the figure.
3. Install the brake disc, hub and steering knuckle assembly (16).
4. Connect the lower control arm, hub and steering knuckle assembly (15).
5. Install the cotter pin (14).
6. Connect the shock absorber and lower suspension arm connection (13).
7. Connect the stabilizer link and lower suspension arm (12).
8. Connect the upper suspension arm and ball joint (11).
9. Install the front vehicle height sensor and disconnect the upper suspension arm connection (10).
10. Connect the tie rod end, hub and steering knuckle assembly (9).
11. Install the cotter pin (8).
12. Install the caliper assembly (7).
13. Install the wheel speed sensor (6).
14. Install the brake hose bracket (5).
15. Tighten the axle nut (4).
Caution: The front wheel hub bearing must not be loaded with the weight of the vehicle before tightening the drive axle nut.
Note: Use a torque wrench when installing.
16. Install the axle cover (3).
17. Install the cotter pin (2).
18. Install the hub cover (1).
19. Check the protective cover for cracks and damage by pressing on it with your finger.
20. Fill the drive shaft with oil.
21. Install the engine crankcase guard.
22. Check and adjust the wheel alignment angles.