2. Install the CV joint boot with the "EUJ" divider (11).
3. Install the small CV joint boot clamp with the "E1M" divider (10).
4. Install the large CV joint boot clamp with the "EUJ" divider (9).
5. Install the "EDJ" dual CV joint boot (8).
Note: Wrap plastic tape around the splines of the EDJ dual CV joint on the drive shaft side to avoid damaging the boot during installation.
6. Install the twin CV joint "EDJ" (7).
7. Install the spring ring (6).
8. Install the dust cover (5).
9. Install the outer ring of the dual CV joint "EDJ" (4).
The original material is posted on the website: mitsubishiman.ru
10. Install the ring clamp (3).
11. Install the small clamp of the dual CV joint boot "EDJ" (2).
12. Install the large clamp of the dual CV joint boot "EDJ" (1).
Note: Install the clamps of the protective boots of the twin CV joint at the appropriate distance from each other (to ensure the required volume of air inside the cover), and then tighten the clamps securely.
Nominal value A:
- (Left-hand drive vehicles): 93±5 mm;
- (Right hand drive vehicles): 85±5 mm.
