Checking the oil level in the rear axle (Mitsubishi Pajero 4)

1. Remove the lower engine crankcase guard and unscrew the filler plug.

2. Check that the oil level is 5 mm above the lower limit.

3. Tighten the filler plug to the recommended tightening torque.

Tightening torque: 50±10 Nm.

(The article was obtained from this portal: www.MitsubishiMan.ru)

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article was reviewed by: Miroslav Rakov

Share with friends:

◀ Previous

Pajero 4: Drive shafts

Next ▶

Checking the rear axle play
Replacing the hub bolt
Checking the resistance force to rotation of the rear wheel hub bearing
Checking the axial clearance of the rear hub bearing
Rear axle — causes of malfunctions

Rear axle oil change
Removal the hub and steering knuckle
Installing the hub and steering knuckle
Checking the resistance moment of the front wheel hub bearing rotation start
Checking the axial clearance in the front wheel hub bearing

Similar materials for other Mitsubishi models