Note: When installing, tighten the bolts to the torques specified in the picture.
1. Install the ring clamp (8).
2. Install the rear drive shaft (7).
3. Install the rear hub assembly (6).
4. Install the wheel speed sensor (5).
5. Tighten the axle nut (4).
Caution: The front wheel hub bearing must not be loaded with the weight of the vehicle before tightening the drive axle nut.
Note: Use a torque wrench when installing.
(Article reprinted from the website mitsubishiman)
Tightening torque: 220±10 Nm.
6. Install the axle cover (3).
7. Install the pin (2).
8. Install the hub cover (1).
9. Install the stabilizer bar.
10. Fill the differential with oil.
11. Replace the seal on the differential side.