Note: When installing, tighten the bolts to the torques specified in the picture.
1. Install the steering knuckle (11).
2. Install the support plate (10).
3. Install the rear hub assembly (9).
4. Install the steering knuckle, rear hub assembly and support plate (8).
5. Connect the steering knuckle and upper suspension arm joint (7).
6. Install the pin (6).
7. Connect the steering knuckle and towing rod joint (5).
8. Connect the steering knuckle and tie rod end joint (4).
9. Tighten the lock nut (3).
10. Install the wheel speed sensor (2).
11. Install the rear vehicle height sensor and disconnect the upper suspension arm connection (1).
12. Check the boot for cracks or damage by pressing on it with your finger.
(The article is reprinted from a web resource mitsubishiman.ru)
13. Install the rear hub assembly.
14. Check and adjust the direction of the headlights.