1. Unscrew the hub cover (1).
2. Remove the cotter pin (2).
3. Remove the axle cover (3).
4. Unscrew the axle nut (4).
Caution: Do not load the front wheel hub bearing with the weight of the vehicle when loosening the wheel drive axle nut.
5. Remove the caliper assembly (5).
Note: Secure the removed caliper assembly with wire so that it does not fall.
Original version of the article on the website: www.MitsubishiMan.ru
6. Remove the brake disc (6).
Note: If removing the brake disc is difficult, install the M8x1.25 bolts as shown in the figure and remove the brake disc by tightening the installed bolts.
7. Disconnect the parking brake cable connection (7).
8. Remove the parking brake pads (8).
9. Disconnect the lower suspension arm and steering knuckle connection (9).
1) Compress the coil spring using a floor jack and remove the lower arm mounting bolt.
2) Lower the floor jack and then remove the coil spring.
10. Remove the steering knuckle, rear hub assembly and support plate.
11. Disconnect the rear drive shaft assembly connection (10).
12. Remove the ABS speed sensor rotor guard (11).
13. Remove the rear hub assembly (12).
14. Remove the support plate (13).