Checking the axial clearance in the rear wheel hub bearing (Mitsubishi Pajero 4)

1. Install the special tool on the front wheel hub assembly and tighten the nut to the specified torque of 220±10 N·m.

2. Measure the clearance in the axial direction.

Maximum allowable value: 0.0 mm.

3. If the maximum permissible value of axial clearance in the front wheel hub bearing is not observed, replace the front wheel hub assembly.

The article is based on data from the website: MITSUBISHIMAN

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article was reviewed by: Miroslav Rakov

Share with friends:

◀ Previous

Pajero 4: Drive shafts

Next ▶

Checking the moment of resistance at the start of rotation of the rear wheel hub bearing
Installing the rear axle hub
Removal the rear axle hub
Front Differential Mount
Solenoid valve and vacuum hose

Removal the steering knuckle
Installing the steering knuckle
Removal the rear drive shaft
Installing the rear drive shaft
Disassembling the rear drive shaft

Similar materials for other Mitsubishi models