Caution! Do not attempt to change the position of the accelerator pedal position sensor. This sensor is installed at the factory with high precision and does not require adjustment.
If such an intervention occurs, the following operations must be performed.
1. Remove the accelerator pedal assembly.
2. Connect the MUT-II device to the diagnostic connector.
3. Loosen the accelerator pedal position sensor mounting bolts.
Fig. 8.6. Adjusting the accelerator pedal sensor: 1 – accelerator pedal travel limiter; 2 – accelerator pedal position sensor; 3 – accelerator pedal lever
4. Make sure that the accelerator pedal lever is in contact with the pedal travel limiter (Fig. 8.6).
5. Turn the ignition key to the "ON" position, but do not start the engine.
6. Turn the accelerator pedal position sensor housing until the sensor output voltage is within the nominal values.
The nominal value is 0.985-1.085V.
7. Tighten the sensor mounting bolts.
8. Reinstall the accelerator pedal assembly.