Contents: Removal ⤓ Installation ⤓
Throttle controller mounting elements
1 - Throttle control servo relay connector; 2 - Throttle control servo relay; 3 - throttle controller connector; 4 - throttle controller; 5 - bracket; 6 - ECU receiver remote control door locks; 7 - connector of the ECU receiver for remote control of door locks.
Removal
Disconnect the ground cable from the battery.
Remove the front floor console.
Disconnect the remote control receiver electronic control unit connector.
Remove the door lock remote control receiver electronic control unit and its mounting bracket.
Disconnect the throttle controller connector and the throttle control servo relay connector.
Remove the throttle control servo relay.
Remove the electronic control unit bracket.
(The original article is on the website: «www.mitsubishiman.ru»)
Installation
Installation is carried out in reverse order, taking into account the following:
When replacing the throttle controller, reset the electronic throttle control system to its original state. To do this:
Turn the ignition key to the ON position and then within one second turn it to the OFF position (LOCK- OFF). Wait 10 seconds.
Install the floor console and remaining parts.