Home Colt Lancer Galant L200 Outlander Pajero Others

Colt 5 (1995-2003, petrol) Colt 4 and 5 (1991-2003) Colt 2 and 3 (1983-1993)

Compression rings — installation (Mitsubishi Colt 5)

0

1. To install compression rings, use special pliers (Figure 2.40).

Figure 2.40. Installing compression rings

Attention! Please note that the rings have different shapes.

Caution! When installing, the manufacturer's mark and size designation on the piston rings must face the piston crown.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article was reviewed by: Peter Ermakov

Share with friends:

◀ Previous

Colt 5: 4G1 engines until 1995

Next ▶

Connecting rod bearings — check
Piston rings — check
Connecting rod and piston group
Oil pump — inspection and assembly
Oil pan — removal and installation

Oil scraper ring — installation
Connecting Rod Bearing Cap — Installation
Installing connecting rod bearings
Crankshaft, flywheel and drive disk
Crankshaft — installation

Similar materials for other Mitsubishi models

➤ Compression Test — All Engines Mitsubishi Lancer 3 and 5 (1984-1992)
➤ Checking the compression pressure in the engine cylinders Mitsubishi Galant 6 and 7 (1987-1998)
➤ Installing oil scraper and compression rings Mitsubishi L200 4 (2005-2014, diesel)
➤ Checking the compression in engine cylinders — general… Mitsubishi Pajero 1 and 2 (1982-1999)
➤ Compression check Mitsubishi Carisma (1995-2004)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

This resource sets cookies 🍪 to avoid bothering you with repeated data entry.