Gearbox Primary Shaft — Assembly (Mitsubishi Colt 5)

Snap ring

11. Select the thickest snap ring that will fit into the groove provided (Figure 11.31).

Caution! The snap ring is not reusable. The snap ring can be opened too wide with special pliers, which will result in incorrect installation of the liner.

[The material is based on data from the website: MitsubishiMan.ru]

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article was reviewed by: Peter Ermakov

Share with friends:

◀ Previous

Colt 5: Manual gearbox F4M21/F5M21

Next ▶

Gearbox Primary Shaft — Check
Primary shaft of the gearbox — disassembly
Gearbox Primary Shaft — Design Description
5th gear synchronizer — check
5th gear synchronizer — design description

Intermediate shaft — design description
Intermediate shaft — disassembly, inspection and assembly
Secondary shaft — description and removal
Secondary shaft of the gearbox W5M31
Differential — design description

Similar materials for other Mitsubishi models

➤ Gearbox / Wheel drive Mitsubishi Lancer 3 and 5 (1984-1992)
➤ Removal and installation the balance shaft Mitsubishi Galant 6 and 7 (1987-1998)
➤ Lubrication of cardan shaft crosspieces Mitsubishi L200 4 (2005-2014, diesel)
➤ Checking the oil level in the gearbox and transfer case… Mitsubishi Outlander 1 (2003-2008)
➤ Gearbox tailpiece seal (or transfer case drive shaft) Mitsubishi Pajero 1 and 2 (1982-1999)
➤ Intermediate shaft seal — removal and installation Mitsubishi Carisma (1995-2004)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet