2. Loosen the adjusting nut securing the cable to the control lever so that the cable and lever are free.
3. Set the control lever to the "N" position.
4. Loosen the range selector lever position sensor mounting bolts and turn it so that the hole in the sensor housing flange aligns with the hole on the end of the control lever (section A-A).
5. While holding the sensor in this position, tighten the mounting bolts to the specified torque.
6. Carefully pull the cable connecting the automatic transmission selector lever to the control valve block in the direction of the arrow and then tighten the adjusting nut.
[The text of the article was obtained from the website: MitsubishiMan.ru]
7. Make sure that the automatic transmission selector lever is in the "N" position.
8. Check that the gears being engaged correspond to the position of the automatic transmission selector lever.
