Cars produced since 1996
Removal
To remove the power steering hydraulic system hoses, perform the following operations in sequence.
1. Drain the fluid from the power steering hydraulic system.
Fig. 13.23. Hoses of the hydraulic system of the power steering of cars produced since 1996: 1 – tank; 2 – bolt (8 Nm); 3 – low pressure hose; 4 – return hose; 5, 6 – O-rings; 7 – connecting nut (12–14 Nm); 8 – bolt (25 Nm); 9 – high pressure hose; 10 – bypass bolt (12–14 Nm); 11 – gasket; 12 – pressure sensor switch connector
2. Remove low pressure hose 3 (Fig. 13.23).
3. Remove tank 1.
4. Remove the return hose 4.
5. Remove the O-ring 5.
6. Remove connector 12 of the pressure sensor switch.
7. Unscrew the bypass bolt 10.
8. Remove gasket 11.
9. Disconnect the high pressure hose 9.
10. Remove the O-ring 6.
Installation
Installation is carried out in the reverse order of removal, taking into account the following.
1. Fill the power steering hydraulic system with fluid.
(The material is based on data from the website: MITSUBISHIMAN)
Cars produced in 1997 and 2001
Removal
To remove the power steering hydraulic hoses, perform the following steps.
1. Drain the fluid from the power steering hydraulic system.
Fig. 13.24. Hoses of the hydraulic system of the power steering of cars produced since 1997: 1 – O-ring sealing gasket; 2 – connecting nut (25 Nm); 3 – hose leading away from the pump; 4 – hose leading to the pump; 5 – bolt (25 Nm); 6 – bolt (10 Nm); 7 – tank; 8 – return hose; 9 – connecting nut (12–14 Nm); 10 – bolt (12 Nm)
Fig. 13.25. Hoses of the hydraulic system of the power steering of cars produced since 2001: 1 – O-ring sealing gasket; 2 – connecting nut (25 Nm); 3 – hose leading away from the pump; 4 – hose leading to the pump; 5 – bolt (25 Nm); 6 – bolt (10 Nm); 7 – tank; 8 – return hose; 9 – connecting nut (12–14 Nm)
2. Remove low pressure hose 4 (Fig. 13.24, 13.25).
3. Remove tank 7.
4. Remove the return hose 8.
5. Remove the O-ring seal.
6. Disconnect the discharge (injection) hose 3 from the pump.
7. Remove the O-ring seal 1.
Installation
Installation is carried out in the reverse order of removal, taking into account the following: fill the hydraulic system of the power steering with fluid.