Removing
- Disconnect the wire from the negative battery terminal.
- Remove the exhaust pipe.
- Remove the power steering pump drive belt.
- Loosen the bolts and remove the power steering pump along with the attached hose and bracket.
Note. Use cord or soft wire to secure the removed power steering pump to the engine compartment so that it does not interfere with the removal of the exhaust manifold.
- Turn out bolts and remove a casing of a final collector.
- Remove the nuts and remove the exhaust manifold and exhaust manifold gasket from the cylinder head.
Examination
- Check the exhaust manifold for cracks or other damage.
- Using a metal ruler and feeler gauges, measure the flatness of the mating surface of the intake manifold.
Deviation from the flatness of the mating surface of the exhaust manifold:
- nominal: no more than 0.15 mm
- maximum allowable: 0.20 mm
Installation
- Installation is carried out in the reverse order of removal, taking into account the following.
- Install the exhaust pipe.
- Install and adjust the tension of the power steering pump drive belt.