Contents: Cordia / Tredia 1.8L Turbo (1984 and…⤓ Cordia/Tredia 1.8L Turbo…⤓ Cordia/Tredia 2.0L (1986-1988) ⤓
Cordia / Tredia 1.8L Turbo (1984 and 1985); Colt, Lancer, Mirage 1.6L (1985)
1. Remove the distributor cap and rotor.
11.2 On Cordia/Tredia 1.8L Turbo models (1984 and 1985); Colt, Lancer, Mirage 1.6L (1985) use special terminals to check the resistance of the pickup coil
1. Terminals for checking the resistance of the receiving coil
2. Check the resistance of the receiving coil using an ohmmeter (11.2).
12.7g Distributor Elements for Cordia and Tredia 1.8L Turbo Models (1984-1985) and Colt, Lancer, Miracie 1.6LM9851
1. Ventilation hole bushing; 2. Lid; 3. Coal; 4. Rotor; 5. Centrifugal regulator springs; 6. Centrifugal regulator plate; 7. Centrifugal governor weights; 8. Centrifugal regulator base; 9. Signal rotor; 10. Receiving coil; 11. Igniter; 12. Breaker; 13. Plate; 14. Washer; 15. Axis; 16. Bearing; 17. Seal; 18. Body; 19. Sealing ring; 20. Pin; 21. Driven gear; 22. Vacuum corrector
3. Replace the coil if the resistance is different from that specified in the specifications section (12.7g).
Cordia/Tredia 1.8L Turbo (1986-1988); Colt, Lancer, Mirage 1.6L (1986-1988)
12.7v Distributor Elements for Cordia and Tredia 1.8L Turbo Models (1986-1988) and Colt, Lancer, Mirage 1.6L (1986-1988)
1. Ventilation hole bushing; 2. Lid; 3. Coal; 4. Rotor; 5. Casing; 6. Sealing ring; 7. Split retaining ring; 8. Vacuum corrector; 9. Screw; 10. Screw; 11. Signal rotor; 12. Screw; 13. Receiving coil; 14. Stator; 15. Rotor axis; 16. Pin; 17. Fastening springs; 18. Centrifugal regulator springs; 19. Centrifugal governor weights; 20. Pin; 21. Driven gear; 22. Sealing ring; 23. Axis; 24. Seal; 25. Body
4. Check the resistance between the wires of the primary distributor coil (12.7V) and replace the receiver coil if necessary.
Cordia/Tredia 2.0L (1986-1988)
12.7b Distributor elements of Cordia and Tredia 2.0L models (1986-1988)
1. Lid; 2. Rotor; 3. Signal generator housing; 4. Receiving coil; 5. Centrifugal regulator plate; 6. Igniter; 7. Igniter casing; 8. Vacuum corrector; 9. Compaction; 10. Signal rotor axis; 11. Cap; 12. Centrifugal regulator springs; 13. Centrifugal governor weights
The original article is on the website (www.mitsubishiman.ru)
5. Disconnect the wires of the receiving coil (12.7b) and check the resistance between the coil terminals.