Contents: Removal ⤓ Installation ⤓
Steering pump mounting elements
1 - bypass bolt; 2 - nipple; 3 - drive belt; 4 - pressure switch sensor connector; 3 - inlet hose; 6 - steering pump.
Removal
Drain the fluid from the power steering system.
Remove the drive belt (3) and the inlet hose (5) (see figure).
Disconnect the pressure switch connector (4).
After unscrewing the bypass bolt (1), remove the ring.
Disconnect the connection.
Remove the power steering pump (6).
Installation
Installation is carried out in reverse order, taking into account the following.
[The article was obtained from this portal: MitsubishiMan.ru]
Fill the hydraulic booster system with fluid.
Bleed the air from the power steering system.