Home Colt Lancer Galant L200 Outlander Pajero Others

Colt 5 (1995-2003, petrol) Colt 4 and 5 (1991-2003) Colt 2 and 3 (1983-1993)

Glow Plugs — Removal and Installation (Mitsubishi Colt 4)

0

Contents: Removal ⤓ Installation ⤓

Removal

Remove the upper portion of the intake manifold.

Disconnect the wire (1), then the current bus (2).

Remove the glow plug (3) and inspect it for external visible damage.

Installation

Carefully screw in the glow plug and tighten to 15-20 Nm.

Connect the current busbar and electrical supply.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article was reviewed by: Nikita Romanov

Share with friends:

◀ Previous

Colt 4 and 5: Fuel system (diesel)

Next ▶

Glow Plugs — Checking
Pre-heating system — general description

Removal air from the fuel system
Elements of the diesel engine injection system
Fuel Shut-Off Valve — Checking and Replacing
Idle Speed Code — Checking and Adjusting
Injectors — removal and installation

Similar materials for other Mitsubishi models

➤ Checking glow plugs Mitsubishi Lancer 3 and 5 (1984-1992)
➤ Checking the condition and replacing spark plugs Mitsubishi Galant 6 and 7 (1987-1998)
➤ Glow plugs Mitsubishi L200 4 (2005-2014, diesel)
➤ Spark plugs — removal and installation Mitsubishi Pajero 1 and 2 (1982-1999)
➤ Checking and cleaning spark plugs Mitsubishi Carisma (1995-2004)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

This resource sets cookies 🍪 to avoid bothering you with repeated data entry.