Checking the voltage at the terminals of the ABS control unit connector (Mitsubishi Colt 5)

1. Measure the voltage between each terminal and terminals 15, 25 or between each terminal and terminal 42 (ground connection) (Figure 14.35). The voltage values at the ABS control unit connector terminals are shown in Table 14.6.

Caution! Voltage at the terminals must not be measured for 3 seconds after the ignition is turned on. During this period, the ABS control unit performs an initial check.

Table 14.6. Voltage values at the terminals of the ABS control unit connector

(The original was published on the website mitsubishiman)