Figure 7.36. Removing and installing the ignition distributor of the 4G1 engine: 1 - High voltage wire tip; 2 - Ignition distributor wiring connector; 3 - Ignition distributor. | 
Figure 7.37. Disassembling and assembling the ignition distributor of the 4G1 engine: 1 - Distributor cap; 2 - Gasket; 3 - Rotor; 4 - Seal; 5 - Ignition distributor housing. |
Installation
1. Remove the upper timing belt cover.
2. Turn the crankshaft clockwise and align the TDC marks (Figure 7.38).
Figure 7.38. Rotate the crankshaft clockwise and align the TDC marks
The original article is on: www.MitsubishiMan.ru
Attention! The piston of the 1st cylinder is at TDC if the TDC mark on the camshaft pulley coincides with the mark on the cylinder head.
3. Align the adjustment mark on the distributor housing with the adjustment mark on the coupling (Fig. 7.39).
Figure 7.39. Align the adjustment mark on the distributor housing with the adjustment mark on the coupling
4. Center the ignition distributor in relation to the engine.