Contents: Inserting the connecting rod holding…⤓ Adjusting the position of the…⤓ Guide for the pin pressing device ⤓ Checking the amount of protrusion of…⤓
Inserting the connecting rod holding device
Adjusting the position of the connecting rod when pressing out the pin
1. Connecting rod
Guide for the pin pressing device
Pressing out and pressing in of the pin is performed in a car service center using the MD 998184-01 device with a hydraulic press and a set of special mandrels. The force during pressing out is about 1.78 Tf, during pressing in – from 4.9 to 16.0 Tf.
If the pin is not pressed in with such force, replace the connecting rod and (or) pin.
Checking the amount of protrusion of the finger on the sides of the piston
When pressing the pin, check the amount of its protrusion (1) on both sides of the piston.
(The original material is here: www.mitsubishiman.ru)
The pressed out pin should pass through the piston with a little effort. Otherwise, replace the piston and (or) pin.