Contents: Removal ⤓ Installation ⤓
Removal
1. Raise and support the vehicle. Remove the transmission. If it is leaking, replace the front gasket.
2. Remove the clutch pressure plate. Check the clutch components.
15.3a Flywheel bolt holes are not symmetrically located (1.5L)
15.3b In engines with symmetrically located bolts, mark the installation position of the flywheel
3. Before removing the flywheel, mark its correct installation position (15.3a, 15.3b)
4. Unscrew the bolts securing the flywheel to the crankshaft, having first locked the flywheel with a screwdriver.
5. Remove the flywheel.
6. Clean the flywheel from oil and grease. Inspect the surface for cracks, scratches and other damage. Check for chipped or missing teeth.
7. Clean and inspect the mating surfaces of the flywheel and crankshaft. If the rear crankshaft oil seal is leaking, replace it.
Installation
8. Place the flywheel on the crankshaft, taking into account the correct location of the bolt holes. Before installing the bolts, lubricate the threads with a sealing compound.
[The article was obtained from this portal: MitsubishiMan.ru]
9. Tighten the bolts to the required tightening torque.
10. Install the remaining parts.