16.2a Quick method for replacing the seal (1.5 l)
16.2b Lubricate the seal with clean engine oil and carefully tap it into place
2. The seal can be replaced without removing the oil pan and seal mount. This method is not recommended, as you may damage the seal during installation. If you want to take a chance, remove the old seal (16.2a). Lubricate the seal with clean engine oil and gently tap it into place (16.2b).
3. The following method is recommended for safe replacement of the oil seal
4. Remove the oil pan, unscrew the bolts, remove the oil seal mount and the mounting gasket.
16.5 Place the seal mount on two wooden blocks and knock out the old seal
5. Place the seal mount on two wooden blocks and knock out the old seal (16.5)
16.6 Install a new oil seal
6. Install a new oil seal (16.6).
7. Lubricate the seal with clean engine oil. Install a new holder gasket.
Original version of the article on the website MITSUBISHIMAN
8. Install the oil seal on the crankshaft.
9. Tighten the oil seal mounting bolts.
10. Install the remaining parts.
11. Start the engine and check for leaks.