2. Start and warm up the engine.
6.3 Lift the throttle cable housing (B) and check the clearance between the limiter and the housing A - loosen the nuts on the bracket to make the adjustment
1. Cable; 2. Casing "B"; 3. Limiter; 4. 1±0.5 mm; 5. Casing "A"
3. Lift up the throttle cable housing (B) and check the clearance between the limiter and housing A (6.3), then loosen the lower bracket bolt.
4. Move the cable until the limiter is at the required distance from casing A.
6. Bottom bracket.
5. Tighten the bracket bolt to the specified torque and check the clearance again.
6. Open the throttle fully and check that the cable is not stuck.