Brake pedal — design description (Mitsubishi Colt 5)

The brake pedal of left-hand drive vehicles is shown in Figure 14.18, the brake pedal of right-hand drive vehicles is shown in Figure 14.19.

Figure 14.18. Brake pedal for left-hand drive vehicles: 1 - Brake light switch wiring connector; 2 - Brake light switch; 3, 5 - Pins; 4 - Washer; 6 - Bolt; 7 - Brake pedal; 8 - Rubber pedal pad; 9 - Return spring; 10 - Bushing; 11 - Finger; 12 - Pedal mounting bracket

Figure 14.19. Brake pedal for right-hand drive vehicles: 1 - Brake light switch wiring connector; 2 - Brake light switch; 3, 5 - Pins; 4 - Washer; 6 - Bolt; 7 - Brake pedal; 8 - Rubber pedal pad; 9 - Return spring; 10 - Bushing; 11 - Finger; 12 - Pedal mounting bracket

(The material is based on data from the website www.mitsubishiman.ru)

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article was reviewed by: Peter Ermakov

Share with friends:

◀ Previous

Colt 5: Brake system

Next ▶

Checking the rear wheel brakes
Checking the front brake disc
Checking and replacing the front brake pads
Functional check of the brake booster valve
Checking the brake light switch

Brake master cylinder and vacuum booster
Checking and adjusting the clearance between the primary piston and the push rod
Front wheel disc brake mechanism
Rear wheel drum brake mechanism
Brake booster valve

Similar materials for other Mitsubishi models