Contents: Removal ⤓ Installation ⤓
Removal
1. Remove the lower right protective cover.
Fig. 3.12. Crankshaft pulley and drive belts: 1 – Power steering pump and air conditioning compressor drive belt; 2 – crankshaft pulley mounting bolt, 177–186 N·m; 3 – crankshaft pulley washer; 4 – crankshaft pulley; 5 – generator drive belt
[Original source of information: MitsubishiMan]
2. Loosen the tension and remove belt 1 (Fig. 3.12) of the power steering pump and air conditioning compressor drive.
3. Loosen the tension and remove the generator drive belt 5.
4. Using a special device, fix the engine crankshaft from turning and unscrew bolt 2 of the crankshaft pulley.
5. Remove washer 3 from the crankshaft pulley.
6. Using a puller or pry bar, remove pulley 4 from the crankshaft.
Installation
Installation is carried out in the reverse order of removal, taking into account the following.
1. Before screwing in the crankshaft pulley mounting bolt, apply a small amount of engine oil to the mating surfaces and threads of the bolt.
2. Install the lower right protective cover.
3. Adjust the tension of the drive belts.