Oil pan and oil pump — design description (Mitsubishi Colt 5)

The sump and oil pump of SOHC engines are shown in Figure 4.23.

Figure 4.23. Oil pan and oil pump for SOHC engines: 1 - Oil pressure sensor; 2 - Oil filter; 3 - Drain plug; 4 - Gasket; 5 - Pallet; 6 - Oil receiver mesh; 7 - Oil receiver mesh gasket; 8 - Pressure reducing valve bolt; 9 - Pressure reducing valve spring; 10 - Pressure reducing valve piston; 11 - Oil seal, 12 - Oil pump housing; 13 - Sealing ring; 14 - Oil pump housing cover; 15 - Outer rotor; 16 - Inner rotor

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article was reviewed by: Peter Ermakov

Share with friends:

◀ Previous

Colt 5: Repair of 4G9 engines

Next ▶

Valve seat replacement and treatment
Valve Stem Guide Bushing — Checking and Replacing
Valve seat — check
Valve springs — checking
Valves — Check for wear

Checking the oil pump
Connecting rod and piston group — design description
Compression rings — installation
Oil scraper ring — installation
Piston and connecting rod — installation

Similar materials for other Mitsubishi models