Contents: Removal ⤓ Installation ⤓
Stabilizer mounting elements
1 - lower arm; 2 - rubber bushing; 3 - ball joint; 4 - bracket (not all models); 5 - sleeve; 6 - stabilizer; 7 - self-locking nut; 8 - bolt stand.
Removal
Remove the cross beam.
Unscrew the self-locking nut and remove the rubber bushings and sleeve.
Unscrew the bolt and remove the stabilizer bushing mounting bracket.
Remove the bushing from the stabilizer.
Remove the anti-roll bar.
Installation
Installation is carried out in reverse order, taking into account the following:
The article was taken from the website [MitsubishiMan.ru]
The stabilizer is installed so that the mark (1) is on the right side. Then install the bushing so that the mark is located as shown in the figure.
Install the cross beam.